This item can only be sold and shipped into the 48 contiguous states within the USA, excluding CA and FL. Additional shipping restrictions by product may apply if noted.FREE Freight on Orders Over $500.*
*Freight charges apply on orders under $500.
An uncured circular flashing material for both inside and outside corner details.
Uses:
Use in place of EPDM uncured flashing for all smaller flashing details such as corners, or patches on an EPDM rubber roof project.
Features:
- 8” uncured EPDM disks with butyl tape laminated to the back for easy use
- Save money over large flashing rolls
Cautions:
Any EPDM surface this product is to be adhered to MUST first be cleaned and primed with RoofKit Seam Primer. RoofKit Seam Primer requires the use of solvent-resistant gloves. These patches stick to themselves very easily; be careful when using. This product also requires the use of RoofKit Rubber Caulk. Read caution labels on all adhesives’, primers’, and sealants’ containers. These materials contain petroleum distillates and are extremely flammable. Care MUST be taken to avoid open flames. Do not smoke when using these products. Safety data sheets (SDS), if required, are available for these products and should be consulted. SDS can be downloaded by clicking here. Turn off all air intake systems on the roof before use. Be sure to comply with all OSHA and other safety standards while working on a roof. Be sure to stay away from overhead obstructions and power lines making sure neither your body nor equipment has contact with them. Read and follow all ladder manufacturers’ warnings and use instructions. Store in dry location away from heat and sunlight.
READ ALL CAUTIONS AND WARNINGS IN THE PRODUCT POCKET APPLICATION GUIDE PAGES 2-3.
